Home / Split keyboards / Larrbogey's
Larrbogey's
| Keyboard | Larrbogey's |
|---|---|
| Developer | larrbogey |
| Separate | yes |
| Stagger | columnar |
| Wireless | no |
| Keys | 36 |
| Availability | prototype |
| Published | 2018-02-18 |
| Features | Low profile keyboard with 3-key thumb cluster. |
| More info | https://www.reddit.com/r/MechanicalKeyboards/comments/7yewrx/form_following_function_split_w_kailh_lowprofile/ |
| Resources | Check the MiniDox if you are looking for an open source alternative. |
Description
This design was an experiment to take advantage of EasyEda's $2 PCB special. It was designed to be used with the wrists on the ground, according to the typing surfaces at both larrbogey's home and work. Desk surfaces level with elbows necessitated an ergonomic super-flat profile. The staggered keys and thumb placement were fitted to the authors hand size. The keyboard is a single pcb with bumpers on the bottom and exposed controllers.The layout is the same as the minidox, but uses a different pin layout and QMK build.
Switch footprint: 17.5 x 18.5 mm (height x width) for the 1u Kailh keycaps rather than the standard 19.05mm (750 mil).
Similar keyboards
- Stag v1 by u/noxxit
- Shark
- Santoku Gen 2 by u/tyered
- SeveredDuck36 by u/CyanDuck17
- Torn by Richard Titmuss